Electronic Brake Control Module: Testing and Inspection

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

* EBCM Reprogramming-Refer to Service Programming System (SPS) (Service Programming System (SPS)).
* Recalibrate the brake pedal position (BPP) sensor (Without JL7). Refer to Brake Pedal Position Sensor Replacement (Brake Pedal Position Sensor Replacement).
* Steering Angle Sensor (SAS) calibration. Refer to Steering Angle Sensor Centering (Procedures).