P0962

DTC P0962

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC P0962 Pressure control solenoid (PCS) Voltage Low

Conditions for Setting the DTC

* No emergency mode.
* Input A/D value is 68 (0.018 V) or less for 0.5 of a second continuously.
* Detection continuously occurs 25 times.


Action Taken When the DTC Sets

* The TCM will request the illumination of malfunction indicator lamp (MIL) and store the DTC when the TCM detects a failure on the first ignition cycle.
* After failure detection the emergency mode is enabled.
* No Lockup Control
* No Engine Torque Reduction Control
* No Engagement Pressure Control
* No 4th Gear
* No Self-Learning Control


Conditions for Clearing the DTC

* The TCM turns OFF the MIL when no further failures are detected on the next 3 consecutive ignition cycles.
* The scan tool can clear the DTC from the TCM history.
* The TCM clears the DTC from the TCM history memory after 40 consecutive ignition cycles without fault.
* The TCM detects the input A/D value is between 0.02V and 0.22V for 12.5 seconds continuously.


Cause of Failure

* The wiring harness or the connector between the pressure control solenoid and the TCM
* The Pressure Control Solenoid
* The TCM