Differential Mount: Service and Repair

Transmission Mount Replacement

Tools Required

J 42055 Transmission Support Fixture


Removal Procedure

Caution: Refer to Battery Disconnect Caution .
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service Intervals) .
3. Remove the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (Service and Repair) .




4. Remove the rear shock absorber lower mounting bolts.
5. Remove the 2 transaxle mount to rear crossmember nuts.




6. Assemble the J 42055 .
7. Install the J 42055 to a transmission jack.
8. Position and firmly secure the J 42055 with the transmission jack to the transmission.
9. Position a transmission jack under the rear suspension crossmember and firmly secure the crossmember to the jack.
10. Using ONLY HAND TOOLS, remove the rear suspension crossmember retaining nuts.
11. Carefully lower the rear crossmember approximately 37 mm (1.5 in).




12. Remove the 2 transaxle mount to differential bolts for the appropriate mount that will be replaced.
13. Remove the appropriate transaxle mount from the vehicle.



Installation Procedure





1. Install the transaxle mount to the vehicle.

Notice: Refer to Fastener Notice .

2. Install the transaxle mount to differential bolts.

Tighten the transaxle mount bracket to differential bolts to 50 N.m (37 lb ft).





3. SLOWLY raise the rear suspension crossmember (still firmly attached to a transmission jack), to the vehicle frame rails.
Guide the transaxle mount studs into the slots in the rear crossmember.
4. Using ONLY HAND TOOLS, install NEW rear suspension crossmember mounting nuts.

Tighten the rear suspension crossmember mounting nuts to 110 N.m (81 lb ft).

5. Remove the transmission jack from the rear suspension crossmember.
6. Release the J 42055 from the transmission, then remove the J 42055 and transmission jack.
7. Install the 4 transaxle mount to rear suspension crossmember nuts.

Tighten the transaxle mount to rear suspension crossmember nuts to 50 N.m (37 lb ft).





8. Install the rear shock absorber lower mounting bolts.

Tighten the rear shock absorber lower mounting bolts to 220 N.m (162 lb ft).

9. Install the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
10. Lower the vehicle.
11. Connect the negative battery cable.

Tighten the negative battery cable bolt to 15 N.m (11 lb ft).

12. Program the transmitters. Refer to Transmitter Programming (N. America and Japan, except Canada) (Programming and Relearning)Transmitter Programming (Canada and Europe) (Programming and Relearning) .