Transmission Control Replacement

Transmission Control Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




2. Remove the shift control linkage adjustment bolt (1).
3. Disconnect the shift control linkage rod from the shift control assembly.




4. Remove the four shift control retaining nuts (1)
5. Lower the vehicle.
6. Remove the front floor console cover. Refer to Front Floor Console Front Cover Replacement (Front Floor Console Front Cover Replacement).




7. Remove the four retainer screws (1).
8. Disconnect the electrical connector from the shift control assembly.
9. Remove the shift control assembly from the tunnel reinforcement.

Installation Procedure

1. Install the shift control assembly to the tunnel reinforcement.





Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the shift control assembly retaining screws (1) and tighten to 30 Nm (22 lb ft).
3. Install the electrical connector to the shift control assembly.
4. Install the front floor console cover. Refer to Front Floor Console Front Cover Replacement (Front Floor Console Front Cover Replacement).
5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




6. Install the shift control assembly retaining nuts (1) and tighten to 30 Nm (22 lb ft).




7. Connect the shift control linkage rod to the shift control assembly.
8. Install the shift control linkage adjustment bolt finger tight.
9. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment (Adjustments).
10. Lower the vehicle.