Wheel Drive Shaft Outer Joint and Boot Replacement
Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools
* CH-48894 Wheel Drive Shaft Boot Clamp Pliers
* J 35910 Drive Axle Seal Clamp Pliers
Removal Procedure
1. Clamp the drive axle shaft in a soft jawed vice.
Caution: Do not cut through the wheel drive shaft inboard or outboard boot during service. Cutting through the boot may damage the sealing surface of the housing and the tripot or the constant velocity joint bushing. Damage to the sealing surface may lead to water and dirt intrusion and premature wear of the constant velocity joint.
2. Use a flat-bladed tool, remove the boot clamp (2) from the constant velocity (CV) joint (1) and the boot (3).
3. Using a pair of side cutters, remove the boot clamp (4) from the boot (3) and the wheel drive shaft (5).
4. Discard the boot clamps (2) and (4). Use NEW clamps only.
5. Using a block of wood and a hammer, remove the CV joint (2) from the wheel drive shaft (1).
6. Remove the boot (1) from the wheel drive shaft (2).
7. Inspect the outer CV joint for damage and wear. Refer to Wheel Drive Shaft Outer Joint Inspection (Wheel Drive Shaft Outer Joint Inspection).
Installation Procedure
1. Position the boot (1) on the wheel drive shaft (2).
2. Ensure that the boot (1) is properly seated in the groove (2) in the wheel drive shaft (3).
3. Place approximately half the grease from the service kit inside the outboard boot and pack the CV joint with the remaining grease.
4. Using a block of wood and a hammer, install the CV joint on the wheel drive shaft (1).
5. Install the boot clamp (4) on the boot (3) and the wheel drive shaft (5).
6. Install the boot clamp (2) on the boot (3) and the CV joint housing (1).
Note: Ensure that the boot clamp is properly positioned around the entire circumference of the boot.
7. Using the J 35910 (3), crimp the boot clamp (1).
8. Tighten the boot clamp.
Tighten the boot clamp to 174 Nm (130 lb ft).
9. Using the CH-48894 (1), close the boot clamp (3). Ensure the boot clamp (3) is securely closed and seated properly on the boot (2).
10. Remove the wheel drive shaft from the bench vise.
11. Distribute the grease within the outer CV joint by rotating the joint in a circular motion four to five times.