Removal and Replacement
Differential Oil Replacement
Removal Procedure
1. Raise and support the vehicle. Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the fill plug (1).
Note: Drain into a suitable container.
3. Remove the drain plug (1).
Installation Procedure
Caution: Refer to Fastener Caution (Fastener Caution).
1. Install the drain plug (1) and tighten to 33 Nm (24 lb ft).
Note: Prior to adding the limited-slip axle additive, the bottle MUST be shaken vigorously for at least one minute to mix the additive thoroughly, then immediately poured into the differential.
2. If the vehicle is equipped with a limited slip differential, install the limited slip additive. Refer to Adhesives, Fluids, Lubricants, and Sealers ([1][2]Fluid Type Specifications).
3. Fill the rear differential with the proper fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers ([1][2]Fluid Type Specifications).
4. Install the rear differential fill plug (1) and tighten to 33 Nm (24 lb ft).
5. Remove the support and lower the vehicle.