Transmission Mount Replacement - Left Side

Transmission Mount Replacement - Left Side

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the left tire and wheel assembly.
3. Remove the left engine splash shield. Refer to Engine Splash Shield Replacement (Right) (Engine Splash Shield Replacement (Right))Engine Splash Shield Replacement (Left) (Engine Splash Shield Replacement (Left)).
4. Position a transmission jack under the transaxle.




5. Remove the transaxle mount upper nuts from the transaxle bracket.
6. Carefully raise the transaxle assembly.




7. Remove the transaxle mount lower nuts from the frame.
8. Remove the transaxle mount from the frame.

Installation Procedure




1. Position the transaxle mount to the frame.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the transaxle mount lower nuts to the frame and tighten to 52 Nm (38 lb ft).
3. Lower the transaxle so the transaxle mount studs install into the transaxle bracket.




4. Install the transaxle mount upper nuts to the transaxle mount and tighten to 52 Nm (38 lb ft).
5. Remove the transmission jack from the transaxle.
6. Install the left engine splash shield. Refer to Engine Splash Shield Replacement (Right) (Engine Splash Shield Replacement (Right))Engine Splash Shield Replacement (Left) (Engine Splash Shield Replacement (Left)).
7. Install the left wheel and tire assembly.
8. Lower the vehicle.