Passenger Presence System Preload Test

Passenger Presence System Preload Test

Introduction

The Passenger Presence System (PPS) requires checking for preloads within each region when the system has been serviced or replaced. If the passenger seat bottom cushion, seat bottom trim, or heater pad has been serviced, reinstalled, or removed for any reason, the procedure below will check for any preloads on the PPS. The PPS module cannot be tested for preload until it is unlocked using SPS programming. A service replacement PPS module does not require an unlock procedure prior to an initial preload test. Once a preload test has been performed, the PPS module will lock regardless of a pass or fail status. If a module needs to be retested, it must first be unlocked with SPS programming. Before you start, read these procedures carefully and completely. For further information regarding the PPS, refer to SIR System Description and Operation (SIR System).

Passenger Presence System Preload System Test Procedure (New Module)

1. Empty the front passenger seat.
2. With the scan tool, perform the Passenger Presence Sensor Learn procedure.
3. If the test fails, adjust the seat bottom trim, and massage the cover to ensure unwanted pressure is not present in the specified area. Perform the Passenger Presence Sensor Learn procedure again to retest after adjustment is made.
4. Once the test successfully completes, cycle the ignition key OFF.
5. Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) after successfully completing the Passenger Presence Sensor Learn procedure to ensure the system is functioning properly.

Passenger Presence System Preload System Test Procedure (Existing Module)

1. With Service Programming System (SPS) (Service Programming System (SPS)) , unlock the PPS module.
2. Empty the front passenger seat.
3. With the scan tool, perform the Passenger Presence Sensor Learn procedure.
4. If the test fails, adjust the seat bottom trim, and massage the cover to ensure unwanted pressure is not present in the specified area, and perform the Passenger Presence Sensor Learn procedure again.
5. Once the test successfully completes, cycle the ignition key OFF.
6. Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) after successfully completing the Passenger Presence Sensor Learn procedure to ensure the system is functioning properly.