Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust

Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust

Removal Procedure

Warning: Refer to Safety Glasses Warning Safety Glasses Warning.


1. Turn the ignition OFF.

Warning: Refer to Battery Disconnect Warning Service Precautions.


2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

3. Remove the power brake booster auxiliary pump. Refer to Power Brake Booster Auxiliary Pump Replacement Service and Repair.




4. Remove the camshaft position (CMP) actuator valve electrical connector♦(1) from the CMP♦(2).




5. Remove the CMP actuator solenoid valve to engine front cover retaining bolt♦(1).

6. Remove the CMP actuator valve♦(2).

7. Inspect the CMP actuator valve seal and replace as necessary.

Installation Procedure

1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.




2. Install the CMP actuator valve♦(2) to the engine front cover.

Caution: Refer to Fastener Caution Fastener Caution.

3. Install the CMP actuator solenoid valve to engine front cover retaining bolt♦(1).

Tighten the bolt to 9♦Nm (80♦lb♦in).




4. Install the CMP valve electrical connector♦(1) to the CMP actuator valve.

5. Install the power brake booster auxiliary pump. Refer to Power Brake Booster Auxiliary Pump Replacement Service and Repair.

6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.