Parking Assist Distance Sensor: Service and Repair
Rear Parking Assist Alarm Sensor Replacement
Removal Procedure
1. Remove rear bumper fascia.
2. Disconnect electrical from the rear object sensor.
Note:
The rear object sensor is a one piece design. Do NOT twist the sensor cap to try and remove the painted cap. Replacement sensor requires painting to match fascia/bumper body color.
3. Lift the locking tabs on the housing and remove the rear object sensor.
Installation Procedure
Note:
Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.
1. Paint the rear object sensor.
2. Ensure the paint does not exceed 6 mils.
3. Insert the sensor into the housing.
4. Connect the electrical connector to the rear object sensor.
5. Install the rear bumper fascia.