Key with Integrated Transmitter Programming (without BTM)

Key with Integrated Transmitter Programming (without BTM)

Keys can be programming in various ways using the procedures outlined below. Using the Replacing Keys procedures will first erase all the known keys from the vehicle. Any existing keys and any new keys will then be programmed. This procedure should be used any time a key is required to be unlearned or erased from a vehicle. If a new key is being learned to a vehicle to replace a damaged, inoperative, or stolen key, the Replacing Keys procedure must be used. This ensures that the old key cannot be used to access or start the vehicle after programming.

The Adding Keys procedure does not erase any keys prior to programming. The procedure will simply program the key into the next available slot. The Adding Keys procedure should only be used when adding an additional key to the vehicle. The Adding Keys procedure should never be used to program a key to a vehicle that is having a key replaced, regardless of the cause for the replacement.

Replacing Keys

Note:

* This procedure may be used with or without existing learned keys being present.

* This procedure will take more than 15 minutes to complete.

* A total of 8 keys maybe be learned to a single vehicle.

* This procedure will only learn the vehicle key information. This procedure will not learn any immobilizer information between the body control module (BCM) and engine control module (ECM).

* If the battery voltage is low, charge the battery before continuing with the procedure.

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).

2. Ensure that all power consuming devices are turned OFF on the vehicle.

3. Select the SPS application and follow the on-screen instructions.

4. Select Reprogram ECU.

5. Select IMMO Immobilizer Learn.

6. Select the Program Transponder or Remote Key function.

7. Follow the on-screen instructions.

8. With a scan tool, clear any DTCs.

Adding Keys

Note:

* This procedure may be used with or without existing learned keys being present.

* This procedure will take more than 15 minutes to complete.

* A total of 8 keys maybe be learned to a single vehicle.

* This procedure will only learn the vehicle key information. This procedure will not learn any immobilizer information between the body control module (BCM) and engine control module (ECM).

* If the battery voltage is low, charge the battery before continuing with the procedure.

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).

2. Ensure that all power consuming devices are turned OFF on the vehicle.

3. Select the SPS application and follow the on-screen instructions.

4. Select Reprogram ECU.

5. Select IMMO Immobilizer Learn.

6. Select the Program Transponder or Remote Key function.

7. Follow the on-screen instructions.

8. With a scan tool, clear any DTCs.