Electronic Suspension Rear Position Sensor Replacement
Electronic Suspension Rear Position Sensor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the tire and wheel assembly, if needed. Refer to Tire and Wheel Removal and Installation (wQ50) Tire and Wheel Removal and Installation (wQ50)Tire and Wheel Removal and Installation (wRT2) Tire and Wheel Removal and Installation (wRT2).
3. Disconnect the position sensor link (1) from the lower control arm.
4. Disconnect the position sensor electrical connector (2).
5. Remove the position sensor nut (1).
6. Remove the position sensor (2) from the vehicle.
Installation Procedure
1. Install the position sensor (2) in the vehicle.
Caution: Refer to Fastener Caution Fastener Caution.
2. Install the position sensor nut (1) and tighten to 15 Nm (11 lb ft).
3. Reconnect the position sensor electrical connector (2).
4. Install the position sensor link (1) to the lower control arm.
5. Install the tire and wheel, if removed. Refer to Tire and Wheel Removal and Installation (wQ50) Tire and Wheel Removal and Installation (wQ50)Tire and Wheel Removal and Installation (wRT2) Tire and Wheel Removal and Installation (wRT2).
6. Remove the supports and lower the vehicle.