Power Outlet Receptacle Inoperative (120 VAC)
Power Outlet Receptacle Malfunction
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
The accessory power receptacles and cigarette lighter receptacle are supplied B+ all the time.
Reference Information
Schematic Reference
Cigar Lighter/Power Outlet Schematics [1][2]Auxiliary Power Outlet
Connector End View Reference
Component Connector End Views 5 Bow Lowered Switch (CM7)
Description and Operation
Power Outlets Description and Operation Description and Operation
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the appropriate accessory power receptacle or cigarette lighter receptacle.
2. Test for less than 5 ohms between the ground circuit terminal C and ground.
• If greater than the specified range, test the ground circuit for an open/high resistance.
3. Verify that a test lamp illuminate between the B+ circuit terminal A and ground.
• If test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
4. If the circuits test normal, test or replace the accessory power receptacle.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.
* Floor Console Accessory Power Receptacle Replacement Floor Console Accessory Power Receptacle Replacement
* Cigar Lighter Housing Replacement Cigar Lighter Housing Replacement