Windshield Side Reveal Molding Replacement (Coupe and Convertible)

Windshield Side Reveal Molding Replacement (Coupe and Convertible)

Removal Procedure





1. Remove the windshield weatherstrip side retainer. Refer to Weatherstrip Side Retainer Replacement (Hardtop) Weatherstrip Side Retainer Replacement (Coupe and Convertible) .





2. Remove the windshield side reveal molding screws.

3. Peel away the reveal molding with the applique from the windshield frame.





4. Remove the applique from the reveal molding.

5. Clean all surfaces.

Installation Procedure





1. Insert the forward edge of the applique into the side reveal molding.

2. Firmly press the applique and the reveal molding together.

3. Replace the foam sealing tape if reusing the reveal molding.

* Extend the tape 2.0 mm (0.08 in) beyond the reveal molding ends.

* Do not stretch the tape to fit. The tape may shrink back, or creep, after installation, resulting in a gap which may cause a leak.





4. Position the windshield side reveal molding on the windshield frame.

Caution:
Refer to Fastener Caution Fastener Caution.

5. Install the windshield side reveal molding screws.

Tighten the windshield side reveal molding screws to 1.8 Nm (16 lb in).





6. Install the windshield weatherstrip side retainer and the weatherstrip. Refer to Weatherstrip Side Retainer Replacement (Hardtop) Weatherstrip Side Retainer Replacement (Coupe and Convertible) .