C0298

Antilock Brake System

Diagnostic Information and Procedures

DTC C0298 or P1571

Circuit Description

C0298

The powertrain control module (PCM) and the electronic brake control module (EBCM) communicate on the serial data link whenever the ignition is ON.

P1571

The PCM supplies 5 volts through an internal resistor, to the EBCM on the requested torque signal circuit. The EBCM toggles this voltage to ground to create the requested torque signal at the PCM.

Conditions for Running the DTC

C0298

The ignition is ON.

P1571

The ignition is ON.
The engine is running at a speed greater than 450 RPM for 5-20 seconds.

Conditions for Setting the DTC

C0298

The EBCM receives a serial data message stating that the PCM has lost the ability to reduce engine torque.

P1571

The PCM receives an invalid requested torque signal for 3 seconds.

Action Taken When the DTC Sets

C0298

The EBCM disables the TCS.
The traction off indicator turns ON.

P1571

The PCM sends a serial data message to the EBCM stating that the PCM has lost the ability to reduce engine torque.
The EBCM sets DTC C0298 as a current DTC for as long as the malfunction is present.

Conditions for Clearing the DTC

C0298

The conditions for setting the DTC are no longer present and you use the scan tool Clear DTCs function.

P1571

The conditions for setting the DTC are no longer present and you use the scan tool Clear DTCs function.
A history DTC clears automatically after 40 consecutive warm-up cycles without a PCM detected failure.

Diagnostic Aids

C0298

A requested torque signal malfunction is only one possible cause for the PCM to lose the ability to perform traction control. DTC C0298 may set due to engine overheating, throttle actuator control failure, loss of ignition timing control by the PCM, etc. If DTC P1571 has not set, refer to Diagnostic System Check - Engine Controls in Engine Controls - 4.8L, 5.3L and 6.0L in order to identify other possible causes of DTC C0298.

P1571

Thoroughly inspect connections or circuitry that may cause an intermittent malfunction. Refer to Testing for Electrical Intermittents, Testing for Intermittent and Poor Connections, Connector Repairs and Wiring Repairs in Wiring Systems.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

4. This step tests for voltage supplied to the EBCM from the PCM.
5. This step tests for a shorted resistor in the PCM or a short to voltage within the requested torque circuit by verifying that a large voltage drop occurs when a test lamp is connected in parallel with the DMM.

DTC C0298 Or P1571 Steps 1 - 8:

DTC C0298 Or P1571 (cont'd) Steps 9 - 14: