Garnish Molding Replacement - Sliding Door

GARNISH MOLDING REPLACEMENT - SLIDING DOOR

TOOLS REQUIRED
J 38778 Door Trim Pad and Garnish Clip Remover

REMOVAL PROCEDURE
1. Remove the swing-out window latch from the door, if equipped.
2. Remove the door handle bezel screws.
3. Remove the door handle bezel.




4. Use J 38778 in order to release the molding retainers.

INSTALLATION PROCEDURE




1. Install the door garnish molding to the vehicle:
1. Align the retainers to the holes in the door.
2. Press the panel in order to engage the retainers into the door.
2. Install the door handle bezel to the door.
3. Install the door handle bezel screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the door handle bezel screws to 2 Nm (18 lb in).

4. Install the swing-out window latch to the door, if equipped.