Trim Replacement - Third Pillar Right

TRIM REPLACEMENT - THIRD PILLAR RIGHT

TOOLS REQUIRED
J 38778 Door Trim Pad and Garnish Clip Remover.

REMOVAL PROCEDURE
1. Remove the C- pillar retaining screw.




2. Use the J 38778 in order to release the fasteners that retain the panel to the vehicle.

INSTALLATION PROCEDURE




1. Install the panel to the vehicle:
1. Align the C- pillar retaining clips with the holes in the body.
2. Press the panel in order to seat the fasteners into place.
2. Install the C- pillar retaining screw.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the C- pillar retaining screw to 2 Nm (18 lb in).