Front Door Window Motor: Service and Repair

Front Door Module Replacement

Removal Procedure

1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement Service and Repair.
2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement Service and Repair.
3. Remove the front door speaker. Refer to Radio Front Speaker Replacement Service and Repair.
4. Disconnect the door wiring harness from the body harness.
5. Disconnect the sash from the glass by squeezing the tabs on both of the glass attachment clips at the same time. With the tabs pressed down, slide the sash in the direction of the snap tabs until the sash clips clear the glass attachment clips.
6. Slide the glass full up and tape in place.
7. Remove the 3 latch screws.
8. Remove the outside handle from the door, including the disconnecting rod. Refer to Front Side Door Outside Handle Replacement Service and Repair.






9. Pull the door harness through hinge face into door cavity and remove the door module (6 screws total).

Installation Procedure






1. Position the front door hardware module to the front door.
2. Align the modular locator pin (1) into the 4�way locating hole (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the front door module screws.

Tighten
Tighten the screws, as shown, to 10 Nm (89 lb in).

4. Install the outside handle including the rod connect. . Refer to Front Side Door Outside Handle Replacement Service and Repair.
5. Remove the tape on the glass and install the glass to the door module sash.
6. Load the door wiring harness through the hinge face and attach to the body harness.
7. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement Service and Repair.
8. Install the front door speaker. Refer to Radio Front Speaker Replacement Service and Repair.
9. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement Service and Repair.