Removal and Replacement

Water in Fuel Indicator Sensor Replacement

Removal Procedure




1. Remove the fuel filter. Refer to Fuel Filter Replacement (Fuel Filter Replacement).
2. Disconnect the water in fuel sensor wiring pigtail (2) from the engine wiring harness electrical connector.




3. Remove the water in fuel sensor (1) from the fuel filter.

Installation Procedure




1. Install the water in fuel sensor (1) to the fuel filter, and tighten 1/2 turn after the seal contacts the filter.




2. Connect the water in fuel sensor wiring pigtail (2) to the engine wiring harness electrical connector.
3. Install the fuel filter. Refer to Fuel Filter Replacement (Fuel Filter Replacement).
4. Prime the fuel system. Refer to Fuel System Priming (Fuel System Priming).
5. Start the engine. If the engine stalls, repeat the above step.
6. Once the engine starts, inspect for fuel leaks.