Evaporative Emission System Hose/Pipe Replacement

Evaporative Emission System Hose/Pipe Replacement

Removal Procedure

Important: Clean the evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible EVAP system contamination.





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Disconnect the EVAP pipe quick connect fitting from the auxiliary EVAP canister. (Body shown removed for clarity). Refer to Plastic Collar Quick Connect Fitting Service Procedures.
3. Disconnect the EVAP pipe quick connect fitting from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.
4. Remove the EVAP pipe clip (2) from the frame crossmember.
5. Remove the EVAP pipe clip (1) from the rear brake front pipes.
6. Remove the EVAP pipe (3) from the vehicle.

Installation Procedure




1. Install the EVAP pipe (3) to the vehicle.
2. Connect the EVAP pipe quick connect fitting to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.
3. Connect the EVAP pipe quick connect fitting to the auxiliary EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service Procedures.
4. Install the EVAP pipe clip (1) to the rear brake front pipes.
5. Install the EVAP pipe clip (2) to the frame crossmember.
6. Lower the vehicle.