Battery Positive Cable Replacement (12V Battery to Auxiliary BEC)

Battery Positive Cable Replacement (12V Battery to Auxiliary BEC)

Removal Procedure




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.
2. Reposition the positive battery cable insulating cover (2) from over the positive terminal.
3. Rotate the lever lock (1) counterclockwise in order to disconnect the positive battery cable.
4. Remove the positive battery cable terminal (3) from the battery.




5. Remove the auxiliary bussed electrical center (BEC) cover (1).




6. Remove the underhood junction block cover.




7. Lift the junction block retainers from the locked position (3) and rotate the retainers to the open position (1).
8. Remove the junction block.




9. Remove the positive battery cable nut (1) from the mega fuse stud.
10. Remove the positive battery cable nut (3) from the auxiliary BEC stud.
11. Disconnect the positive battery cable connector (2) from the underhood BEC.




12. Remove the positive battery cable assembly (1) from the vehicle.

Installation Procedure




1. Install the positive battery cable assembly (1) to the vehicle.
2. Install the positive battery cable leads to the mega fuse and auxiliary BEC studs.




3. Connect the positive battery cable connector (2) to the underhood BEC.

Caution: Refer to Fastener Caution Fastener Caution.

4. Install the positive battery cable nut (3) to the auxiliary BEC stud and tighten to 9 Nm (80 lb in).
5. Install the positive battery cable nut (1) to the mega fuse stud and tighten to 9 Nm (80 lb in).




6. Ensure that the junction block retainers are in the open position (1).
7. Position and align the junction block to the 4 bracket pivots (2), once the pivots are engaged, push the retainers down into the locked position (3).




8. Install the underhood junction block cover.




9. Install the auxiliary BEC cover (1).




10. Install the positive battery cable terminal (3) to the battery.
11. Rotate the lever lock (1) clockwise until an audible click is heard in order to connect the positive battery cable.
12. Position the positive battery cable insulating cover (2) over the positive terminal.
13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.