Engine Oil Pan - Installation

INSTALLATION





1. Apply Mopar(R) Engine RTV GEN II at the oil pump to engine block parting lines (1).




2. Install oil pan gasket (2) to the block.
3. Install oil pan (3). Tighten screws to 12 Nm (105 in. lbs.).
4. Install oil filter adapter (5) and gasket (4). Tighten screws to 12 Nm (105 in. lbs.).
5. Turbocharger Equipped Vehicles:
- Replace oil cooler seal
- Lubricate seal and position oil cooler to oil filter adapter, aligning notch to tab
- Install oil cooler connector bolt. Torque connector bolt to 55 Nm (41 ft. lbs.).





6. Install oil drain plug (2) and oil filter (1).




7. Install structural collar (2)Installation.




8. Install lower torque strut (5)Torque Strut - Installation.
9. Turbocharger Equipped Vehicles: Install turbocharger to charge air cooler hose assembly Charge Air Cooler and Hoses - Installation.




10. Lower vehicle and fill engine crankcase (1) with proper oil to correct level (3).
11. Start engine and check for leaks.