Airbag System Verification Test

AIRBAG SYSTEM VERIFICATION TEST

1. Remove all special tools and jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: Turn the ignition on, then reconnect the 12-volt battery. Wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

2. Connect the scan tool to the Data Link Connector - use the most current software available.
3. If sent here from an Occupant Classification System (OCS) related diagnostic procedure or if repairs were made to the OCS, perform the OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST. Occupant Classification Module (OCM) System Verification Test.
4. With the scan tool, erase stored DTCs in ORC.
5. Turn the ignition off, and wait 15 seconds, then turn the ignition on.
6. Wait one minute, and read active DTCs in all Airbag System Modules.
7. Read the stored DTCs in the ORC.

Are any DTCs present or if the original condition still present?

Yes

- Repair is not complete. Testing and Inspection.

No

- Repair is complete.