OCS Verification Test

OCS VERIFICATION TEST
OCCUPANT CLASSIFICATION MODULE (OCS) VERIFICATION TEST
1. Remove any special tools or jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

2. Connect the scan tool to the Data Link Connector - use the most current software available.
3. With the scan tool to erase stored OCM DTCs.
4. Turn the ignition off, and wait 15 seconds, then turn the ignition on.
5. Wait one minute, and read active codes and if there are none present read the stored codes.
6. If the scan tool shows any active or stored codes, follow path specified for that trouble code. If no active or stored codes are present, the repair is complete.

Are any DTCs present or is the original condition still present?

Yes

- Repair is not complete. Testing and Inspection.

No

- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.