Kneeblocker - Installation

INSTALLATION

NOTE: LHD model shown in illustrations. RHD model similar.





1. Engage the retaining tabs that secure the knee blocker (2) to the instrument panel support (1).
2. Install the four screws (3) that secure the knee blocker to the instrument panel support. Tighten the bolts to 4 Nm (35 in. lbs.) in the following sequence:
- Upper outboard
- Upper inboard
- Lower outboard
- Lower inboard





3. Install the screws (3) that secure the knee blocker cover (2) to the driver side of the instrument panel (1). Tighten the screws securely.