P1596
Test 1:
Tests 2 - 5:
Tests 6 - 10:
SYMPTOM
P1596-SPEED CONTROL SWITCH ALWAYS HIGH
WHEN MONITORED
With the ignition key ON.
SET CONDITION
An open circuit is detected in the speed control ON/OFF switch circuit. The circuit must be above 4.8 volts for more than 2 minutes to set the DTC.
POSSIBLE CAUSES
- Intermittent condition
- Speed control ON/OFF switch
- Clockspring signal/ground circuit open
- Speed control switch signal CKT short to voltage
- Speed control SW SIG CKT open PCM to clock spring
- Speed control SW SIG CKT open clockspring to S/C switch
- Speed control switch ground circuit open clockspring to S/C switch
- Speed control switch ground circuit open PCM to clockspring
- Powertrain control module