Intake Manifold - Installation

INSTALLATION





1. Install intake manifold gaskets.
2. Position intake manifold.
3. Install the ignition coils (1,2) and manifold retaining bolts and torque from the center bolts, moving front to back in a crisscross pattern to 12Nm (106 in. lbs.).




4. Install throttle body assembly (3), if removed.
5. Install fuel rail Fuel Rail - Installation.
6. Connect electrical connectors for the following components:
- Manifold Absolute Pressure (MAP) Sensor
- Electronic Throttle Control (ETC) (2)
- Coolant Temperature (CTS) Sensor
- Ignition coil
- Fuel injectors





7. Install top oil dipstick tube retaining bolt and ground strap.
8. Install spark plug wires (3).
9. Connect generator electrical connections.
10. Install the wiper module Wiper Module - Installation.
11. Install resonator assembly and air inlet hose.
12. Connect negative cable to battery.