A/C and Heater Control - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.





1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel from the instrument panel and disconnect the wire harness connectors (3 and 4) from the A/C-heater control (1)Instrument Panel - Removal.
3. Place the center bezel on a workbench and remove the screws (2) that secure the A/C-heater control to the center bezel.
4. Remove the A/C-heater control from the center bezel.