Headliner - Installation

INSTALLATION






CAUTION: It is necessary to fold the corner and the side up between the C and D pillar area of the headliner to remove from the vehicle. The corner must be folded up and not down to avoid damaging the headliner.

1. Install the headliner (2) to the roof (1).





2. Connect the lift gate washer drain hose (4) to the Center High Mounted Stop Lamp (CHMSL) and install to the lift gate, Center Mounted Brake Lamp - Installation.
3. Connect the electrical connector for the lift gate harness (1).
4. Install the clip (3) to the header roof (2).





5. Connect the radio and/or satellite electrical connectors along the left A-pillar.





6. Connect the satellite radio body antenna connector (1).
7. Connect the power connector (2).
8. Connect the radio body antenna connector (3).





9. Attach the harness clip (2) to the D-pillar body (1).
10. Connect the DVD electrical connectors (3).






NOTE: Install a union where the lift gate washer hose was cut during removal.

11. Connect the lift gate washer hoses (1) with a union at the A-pillar.





12. Connect the sunroof motor jumper (5).
13. Remove the tape backing from the spacer foam blocker (3), use hand pressure on the foam blocker to stick the headliner and the sunroof together.
14. Use hand pressure at the dual lock areas (1) of the headliner (4) to make sure the headliner sticks to the sunroof (2).





15. Connect the electrical connector (1) for the mirror (2).





16. Connect the body harness connectors (3).
17. Attach the harness clip (1) to the D-pillar body (2).
18. Install the assist handles, Grab Handle - Installation.
19. Install the visors, Visor - Installation.
20. Install the visor supports, Visor Support - Installation.
21. Install the overhead console, Overhead Console - Installation.
22. Install the A-pillar trim and grab handles, A-Pillar Trim Panel-Installation.
23. Install the upper B-pillar trim, B-Pillar Trim Panel-Installation.
24. Install the quarter trim panels, Quarter Trim Panel - Installation.
25. Install the sunroof opening trim ring, if equipped.
26. Connect the negative battery cable.