TPM Verification Test

TPM VERIFICATION



1. TIRE PRESSURE MONITORING (TPM)

Was the Wireless Control Module (WCM) replaced during the test procedure?

Yes

- Go To 2

No

- Go To 3

2. WIRELESS CONTROL MODULE (WCM)

NOTE: When entering the Personal Identification Number (PIN), care should be taken because the WCM will only allow three consecutive attempts to enter the correct PIN. If three consecutive incorrect PINs are entered the WCM will lock out the scan tool. To exit Lock Mode, the ignition key must remain in the Run position for one hour. All accessories must be off. A battery charger connected to the battery during this time period is recommended.

1. Reconnect the previously removed and/or disconnected components and connectors.
2. Obtain the vehicles unique Personal Identification Number (PIN) assigned to its original WCM. This number can be obtained from the vehicle invoice or from the Chrysler Customer Center (Phone 1-800-992-1997).
3. With the scan tool, select Miscellaneous Functions, Wireless Control Module (WCM). Then select the desired procedure and follow the display on the scan tool.
4. If the WCM was replaced, all the customer's keys must be programmed to the new module. Use the scan tool and the Program Key procedure
5. With the scan tool, erase all DTCs. Perform five ignition key cycles, leaving the key on for at least 90 seconds each cycle.
6. Drive the vehicle for a minimum of 10 minutes while maintaining a continuous speed above 24 km/h (15 mph). During this time the system learns the new sensor ID code and will clear any DTCs automatically.
7. With the scan tool, read WCM DTCs.

Are there any DTCs present?

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

No

- Repair is complete.

3. TIRE PRESSURE MONITORING (TPM) SENSOR REPLACE
1. Connect the previously removed and/or disconnected components and harness connectors.
2. Drive the vehicle for a minimum of 10 minutes while maintaining a continuous speed above 24 km/h (15 mph). During this time the system learns the new sensor ID code and clears any DTC(s) automatically.
3. With the scan tool, read WCM DTCs.

Are there any DTCs present?

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

No

- Repair is complete.