Instrument Panel Glove Box - Installation

INSTALLATION





1. Position the glove box surround (2) back into the instrument panel opening (1) and seat fully.





2. Install the glove box surround screws (1).





3. Position the owners guide shelf (3) back into the surround and insert the shelf legs into the holes in the surround (1).
4. Seat the rear retaining clips (2) fully.





5. Install the passenger side end cap (1) and seat the retaining clips fully.
6. Position the door seal back into place if necessary.





7. Snap the lower glove box hinges (1) over the pivots and rotate up.
8. Squeeze the outboard open stop tab (4) inward and push the outboard side of the glove box up to engage the stop tab.
9. Squeeze the inboard open stop tab (3) inward and push the inboard side of the glove box up to engage the stop tab and close the glove box.
10. Connect the stabilizer clip (2) to the outer side of the box compartment and verify the glove box operation.