Disc Brake Caliper - Removal

REMOVAL

NOTE: Front brake caliper shown, rear calipers similar.

1. Drain small amount of fluid from the master cylinder brake reservoir with a clean suction gun.
2. Install a prop rod on the brake pedal to keep pressure on the brake system. Holding the pedal in this position will isolate the master cylinder from the hydraulic brake system and will not allow brake fluid to drain out of the brake fluid reservoir while the brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
3. Raise and support the vehicle Maintenance.
4. Remove the wheel and tire assembly.




5. Bottom the caliper pistons into the caliper.
6. Remove the brake caliper tension clip (1) by pressing rearward on the front of the clip (2) while pulling the clip out (3) from the caliper.





7. Remove the brake hose banjo bolt (4) and gasket washers. Discard the gasket washers.
8. Remove the caliper slide dust bolt shields and loosen the brake caliper slide bolts (guide pins) (1).
9. Remove the caliper (3) from the adapter.
10. Remove and transfer any necessary components.