Seat Cushion Side Shields - Installation

INSTALLATION

NOTE: Left hand drive model shown. Right hand drive model similar.





1. Connect the electrical connector (2) to the switches, if equipped. Make sure the connectors are fully engaged to the switches.





2. Position the seat cushion side trim panel (2) to the seat.
3. Slide the seat cushion side trim panel rearward and engage the trim panel to the three mounting brackets located on the outboard seat frame (3).
4. Install the screw (1) that secures the seat cushion side trim panel to the seat frame. Tighten the screw securely.





5. Carefully engage the tabs (2) that secure the seat cushion side trim panel (3) to the rear of the seat (1). Make sure the retaining tabs are fully engaged.





6. Install the seat belt anchor trim panel (1) onto the outboard seat cushion side trim panel (2). Make sure the trim panels are fully engaged to each other.
7. Connect the negative battery cable.
8. Verify proper power seat operation.