Cylinder Head Cover(s) - Removal

REMOVAL





1. Remove the oil fill cap (1).
2. Remove the engine cover (2).





3. Perform the fuel pressure release procedure Service and Repair.
4. Disconnect and isolate the negative battery cable (2).





5. Disconnect the EVAP vacuum line (1) at the throttle body.
6. Disconnect the fuel supply line (2) at the fuel rail.
7. Disconnect the make up air hose (3) at the intake manifold.





8. Disconnect the ignition coil electrical connectors (1).
9. Remove the ignition coil retaining bolts (3).





10. Remove the ignition coils (1).
11. Remove the wiring harness retainers at the cylinder head cover and position wiring harness aside.





12. Using the sequence shown, remove the cylinder head cover retaining bolts.





13. Remove the cylinder head cover (2).

NOTE: The cylinder head cover gasket (1) may be used again, provided no cuts, tears, or deformation have occurred.

14. Inspect the cylinder head cover gasket (1), replace if necessary.