Floor Console - Removal

REMOVAL

Special Tools:






BASE FLOOR CONSOLE





1. Remove the front plug (2) and clip (3).
2. Slide the console (1) forward while lifting slightly (4) to clear the rear load floor hook.
3. Remove the console (1).

PREMIUM FLOOR CONSOLE





1. Pull up on the bottom release handle (3) in the front (2) of the console (1).
2. Lift the rear of the console (4) up several inches.
3. Pull rearward to disengage from floor and remove console (1).

FULL FLOOR CONSOLE





1. Disconnect the negative battery cable.
2. Using (C-4755), pry around the perimeter of the upper console bezel (1) to disengage the retaining clips.
3. Position the upper console bezel (1) rearward. Do not remove the bezel at this time.





4. Rotate the upper console bezel (1) and disconnect the wiring harnesses (2).
5. Remove the upper console bezel (1).





6. Remove the two fasteners (2) securing the floor console (1) to the instrument panel.
7. Remove the pushpin fastener (5) securing the floor console (1) to the instrument panel. Repeat on the opposite side.
8. Remove the two fasteners (3) securing the floor console to the floorpan bracket (4). Repeat on the opposite side.
9. Pull rearward to disengage and remove the floor console (1).