Clockspring - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

CAUTION: If the clockspring is not properly centered in relation to the Steering Angle Sensor (SAS), steering wheel, steering shaft and steering gear, it may be damaged or Diagnostic Trouble Codes (DTC) may be set in the SAS. Procedures . Service replacement clocksprings are shipped pre-centered and with a locking pin installed. This locking pin should not be removed until the clockspring has been installed on the steering column.





1. Reinstall the multi-function switch onto the clockspring. Multifunction Switch - Installation.
2. With the centered clockspring rotor and case secured to each other, or with the plastic locking pin installed, carefully slide the clockspring down over the steering column upper shaft far enough to access and reconnect the following instrument panel wire harness connectors and their wiring retainers to the clockspring, as the vehicle is equipped:
a. Multi-function switch connector
b. Steering Angle Sensor (SAS) connector
c. Two clockspring connectors
d. Adjustable pedal switch connector, if the vehicle is so equipped.
3. Position the clockspring (2) onto the steering column housing (3).
4. From above the steering column, install and tighten the two captive screws (1) that secure the back of the clockspring to the steering column. Tighten the screws to 3 Nm (25 in. lbs.).





5. Install and tighten the screw (2) on the face of the clockspring that secures the clockspring (1) to the steering column. Tighten the screw to 3 Nm (25 in. lbs.).
6. Reinstall the upper and lower shrouds onto the steering column housing. Steering Column Shroud - Installation.
7. Reinstall the steering wheel onto the steering column. Installation.

NOTE: When reinstalling the steering wheel, be certain to index the engagement dowel/drive pin on the upper surface of the clockspring rotor with the slot cast into the lower surface of the steering wheel armature hub.

8. Remove the plastic locking pin or any other device that is being used to secure the clockspring rotor to the clockspring case to maintain clockspring centering.
9. Reconnect the steering wheel wire harness connector to the upper clockspring connector receptacle. Be certain that the steering wheel wire harness is routed between the steering wheel back trim cover and the steering wheel armature.
10. Reinstall the driver airbag onto the steering wheel. Driver Air Bag - Installation.
11. Reconnect the battery negative cable.

NOTE: Proper clockspring installation must also be confirmed by viewing the SAS Menu Item, Data Display function using a diagnostic scan tool.