Engine Timing Cover(s) - Installation

INSTALLATION





1. Install a new front crankshaft oil seal.
2. Obtain a seal pilot (1) installation tool from a crankshaft front seal service kit and install the pilot into the seal.
3. Apply a bead of Mopar(R) Silicone Rubber Adhesive Sealant or equivalent to the gear housing cover. Be sure to surround all through holes.










4. Using the seal pilot to (1) align the cover , install the cover to the housing and install the bolts. Tighten the bolts at the 3 and 9 o'clock position finger tight, then in a clockwise direction starting at the 3 o'clock position, tighten to 24 Nm (18 ft. lbs).
5. Snug, but do not torque one bolt at the 3 o'clock and 9 o'clock positions. This centers the seal on the crankshaft.
6. Tighten the bolts to 24 Nm (18 ft. lbs.) in a circular pattern.
7. Remove the seal pilot. Install front seal dust shield.

8. Raise and support vehicle.
9. Install the crankshaft damper Vibration Damper - Installation.









10. Install the fan support/hub assembly, and tighten bolts to 32 Nm (24 ft. lbs.).





11. Install power steering pump Power Steering Pump - Installation.

12. Install accessory drive belt tensioner. Tighten bolt to 43 Nm (32 ft. lbs.).
13. Install the accessory drive belt Serpentine Accessory Drive Belt - Installation.
14. Install the cooling fan/drive/shroud assembly Electric Radiator Fan - Installation
15. Install the radiator upper hose and clamps.
16. Fill the coolant system Service and Repair.
17. Connect both battery negative cables.
18. Start engine and inspect for leaks.