Valve Body - Installation

INSTALLATION





1. Connect the linkage rod to the valve body and install to the transmission.
2. Install the clip to the linkage rod (1).





3. Install the valve body bolts. The longer bolts (1) are installed in these positions.





4. Install the remaining bolts. Hand tighten the bolts evenly in sequence. Final tightening of the bolts to 10 Nm (89 in. lbs.) in sequence.





5. Install the speed sensor connector (1) to the solenoid clamp.





6. Install the sensor (3) to the valve body, install the oil temperature sensor clamp (2) and the bolt (1). Tighten the bolt to 7 Nm (62 in. lbs.).





7. Connect the solenoid connectors and the speed sensor connectors (1).
8. Connect the wire harness to the clamps.






CAUTION: Do not over apply sealant as fluid contamination may occur.

9. Install a small and uniform bead of 3 bond gasket sealer to the side cover.





10. Install the side cover and the side cover bolts (1). Tighten the bolts to 25 Nm (18 ft. lbs.)
11. Install the electric cooling fan. Cooling Fan - Removal
12. Install the battery tray. Battery Tray - Removal
13. Install the engine cover (1) Air Cleaner - Removal.
14. Re-fill the transmission fluid Procedures.