Wiper Arm Linkage - Removal

REMOVAL






NOTE: The front wiper motor can be removed from the wiper linkage module and is serviced independently from the remainder of the wiper linkage module for this vehicle. Front Wiper Motor - Removal.

1. Disconnect and isolate the battery negative cable.
2. Remove both front wiper arms from the wiper pivots. Front Wiper Arm - Removal.
3. Remove the cowl plenum cover/grille panel from over the front wiper linkage module. Cowl Panel Cover - Removal.
4. Remove the two screws (3) that secure the module bracket to the cowl plenum.
5. Disengage the knob-like rubber insulator from the hole in the rearward wall of the cowl plenum.
6. Disconnect the wire harness connector (2) from the connector receptacle for the front wiper motor.
7. Disengage the wire harness retainer (1) from the linkage module bracket.
8. Remove the front wiper linkage module from the cowl plenum as a unit.