Test A: Air Bag Warning Ind. Is ON Continuously - RCM Disconnected or Inop. Loss of Batt. Feed/Loss of Signal Gnd.

A1 - A2:

A3:

A4 - A5:

A6 - A7:

Normal Operation

NOTE: During normal operation the air bag indicator will be lit continuously for 6 seconds after the ignition switch is placed in the RUN position and after five cycles of a Lamp Fault Code (LFC) if a fault exists. Be sure to cycle the ignition switch and look for a 6 second indicator prove-out without LFCs.

The Restraints Control Module (RCM) will communicate Diagnostic Trouble Codes (DTCs) to the scan tool using the Data Link Connector (DLC). If the scan tool displays NO COMMUNICATION when retrieving continuous DTCs, use Pinpoint Test U to troubleshoot the system. Test U: No Communication With the Restraint Control Module (RCM)

Possible Causes
An air bag indicator that is illuminated continuously could be caused by one of the following:
^ circuitry
^ the ignition circuit damaged
^ the RCM disconnected from the vehicle harness
^ a loss of RCM ground circuit
^ the RCM inoperative
^ shorting bar or camming beam in connector