Test I: LFC 34/DTC B1883 - Passenger Pretensioner Circuit Short to Ground

PINPOINT TEST I: LFC 34/DTC B1883 - PASSENGER PRETENSIONER CIRCUIT SHORT TO GROUND

I1-I3:

I3-I5:

I6:

NOTE: There is no restraint system diagnostic tool for the safety belt buckle pretensioners. If the ignition switch is set to RUN or START with the safety belt buckle pretensioner electrical connector(s) disconnected, the DTC for an open circuit will be activated.

Normal Operation
The safety belt pretensioners are activated by the RCM to remove excessive slack from the safety belt webbing when an impact exceeding preprogrammed limits is detected.

The restraints control module (RCM) checks all of the safety belt pretensioners for faults. If the RCM detects a short to ground fault on any of the safety belt pretensioner circuits, it will store diagnostic trouble code (DTC) B1883 in memory and flash lamp fault code (LFC) 34 (or higher priority code if one exists) on the air bag indicator.

Fault Conditions
The RCM monitors for the following fault conditions:
- Circuit short to ground

Possible Causes
A safety belt pretensioner fault can be caused by:
- faulted wiring, terminals or connectors.
- a faulted pretensioner.
- a faulted RCM.