Switch State Control
KEY PROGRAMMING SWITCH STATE CONTROLWorldwide Diagnostic System (WDS):
Special Tool(s)
NOTE:
- The spare key programming switch is a diagnostic tool programmable switch which provides the capability to enable/disable the customer spare key programming procedure. This procedure is in the Owner's Literature spare key programming procedure and under Key Programming Using Two Programmed Key. This programmable switch is provided as a convenience for customers who may not want the spare key programming procedure available to the vehicle driver.
- The spare key programming switch state can be viewed by instrument cluster PID SPARE_KY.
1. Insert a programmed ignition key into the ignition lock cylinder and turn the ignition switch to RUN.
2. Using the diagnostic tool select instrument cluster from the menu. Select SECURITY ACCESS to obtain security access.
3. NOTE: The default setting on delivery of all new vehicles is
From the diagnostic tool menu, select the SPARE KEY PROGRAMMING SWITCH selection and set to the desired setting:
Unlimited Key Mode Programming
Enabling Unlimited Key Mode
NOTE: Unlimited key mode is intended for use by those fleet customers who need more than 8 keys for their vehicle.
1. The customer must choose an 8-digit, non-00,00,00,00 number to be programmed to all of their vehicles. All customer vehicles need to use the same number. Valid digits are 0-9 plus the letters A-F.
2. NOTE: If the instrument cluster PID: UNLIMITED TRANSPONDER KEY ID is not displayed on screen, unlimited key mode is turned on, and must be turned off before viewing the stored code. To view/change the stored code, follow the procedure for turning off unlimited key mode below. Check the PID: UNLIMITED TRANSPONDER KEY ID and compare its value against the code chosen in Step 1.
3. Using the diagnostic tool, select instrument cluster from the menu. Follow SECURITY ACCESS to obtain security access.
4. Turn OFF the unlimited key mode to view the security key PID.
5. If the Unlimited Transponder Security Key PID was 00,00,00,00, select Active Command: SET UNLIMITED TRANSPONDER KEY. Enter the 8-digit code chosen by the user.
6. Select: ENABLE UNLIMITED KEY MODE/RESET SERVICE BIT, if applicable.
7. Select: IGNITION CODE ERASE.
8. Disconnect the diagnostic tool and turn the ignition keys off.
9. Program in 2 ignition keys to enable the vehicle by cycling the keys from OFF to RUN.
10. Program any additional keys using either Key Programming Using Two Programmed Keys or Key Programming Using Diagnostic Equipment.
Disabling Unlimited Key Mode
1. Using a diagnostic tool, select instrument cluster from the menu. Follow SECURITY ACCESS to obtain security access.
2. Select: DISABLE UNLIMITED KEY MODE.
3. Select: IGNITION KEY CODE ERASE and RESET SERVICE BIT, if applicable.
4. Disconnect the diagnostic tool and turn the ignition switch to OFF.
5. Program in 2 keys to enable the vehicle.
6. Program any additional keys using either Key Programming Using Two Programmed Keys or Key Programming Using Diagnostic Equipment.