Instrument Panel Cluster (IPC)

Instrument Panel Cluster (IPC)









Removal

1. If installing a new Instrument Panel Cluster (IPC), upload the module configuration information to the scan tool using the Programmable Module Installation (PMI) procedure.

2. Remove the IPC finish panel.

3. Remove the 4 screws and the IPC.
- Disconnect the electrical connector.

Installation

1. Position the IPC in the instrument panel and connect the electrical connector.

2. Install the 4 IPC screws.

3. Install the IPC finish panel.

4. If installing a new IPC, download the IPC configuration information from the scan tool into the new IPC. For additional information, refer to PMI in Information Bus. Programming and Relearning

5. NOTE: If a new IPC is installed, the IPC and the PCM require a parameter reset to allow the IPC and the PCM to recognize each other. Failure to carry out the parameter reset to the IPC and the PCM will result in a no start condition on both Passive Anti-Theft System (PATS) and non-PATS vehicles.

If installing a new IPC, carry out the parameter reset procedure. Passive Anti-Theft System (PATS)