Parking Assist Distance Sensor: Service and Repair

Parking Aid Sensor





NOTE: Standard bumper shown, step bumper similar.










Removal and Installation

NOTE: Right outer parking aid sensors shown, right inner, left outer and left inner similar.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Disconnect the parking aid sensor electrical connector.

3. Remove the parking aid sensor(s).
- Press the parking aid sensor retaining tabs to release the sensor(s) from the parking aid sensor bezel.

4. To install, reverse the removal procedure.
- Using the scan tool, verify that the parking aid sensor distance PIDs read no object present, and that the parking aid sensor attenuation PIDs read between 0.8-1.6 ms.

5. Carry out the azimuth and elevation test. For additional information, refer to Azimuth System Check Azimuth System Check and Elevation System Check Elevation System Check