Windshield Washer Pump: Service and Repair

Washer Pump and Reservoir

Removal

1. Remove the battery tray. For additional information, refer to Battery.

2. Remove the windshield wiper reservoir nut and bolt.
- To install, tighten to 4 Nm (35 lb-in).

3. Disconnect the filler hose from the reservoir.

4. Disconnect the washer pump electrical connector and wiring harness locator.

5. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: If necessary, drain the windshield washer reservoir after removal.
Disconnect the windshield washer hose and remove the washer pump and reservoir.

6. NOTICE: Do not operate the windshield washer pump before filling the windshield washer reservoir. Failure to do so could result in premature pump failure.

To install, reverse the removal procedure.