Pinpoint Test Z: The Anti-Theft Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test Z: The Anti-Theft Indicator Is Never/Always On

Normal Operation

The Passive Anti-Theft System (PATS) indicator proves out for 3 seconds when the key is turned to the RUN or START position under normal operation. If there is a PATS concern, the anti-theft indicator either flashes rapidly or glows steadily (for more than 3 seconds) when the key is turned to the RUN or the START position. The PATS also flashes the anti-theft indicator every 2 seconds at key off to act as a visual theft deterrent. The anti-theft indicator operation is controlled by the Instrument Cluster (IC)

NOTE: If DTC U0100 is set in the IC, other observable symptoms may be an inoperative speedometer, tachometer or odometer.

This pinpoint test is intended to diagnose the following:

- PATS concern
- IC




PINPOINT TEST Z: THE ANTI-THEFT INDICATOR IS NEVER/ALWAYS ON

-------------------------------------------------
Z1 CHECK THE ANTI-THEFT INDICATOR DURING BULB PROVE-OUT



- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger .
- Select the IC anti-theft indicator (THEFT_LMP) active command. Command the anti-theft indicator on and off. Observe the anti-theft indicator.
- Does the anti-theft indicator illuminate when commanded on and turn off when command off ?

Yes
GO to Z2.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------
Z2 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST



- Check for recorded DTCs from the IC self-test.
- Are any PATS related DTCs recorded?

Yes
REFER to Antitheft and Alarm Systems.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------