Selector Lever

Selector Lever









Removal and Installation

NOTE: The Transmission Range (TR) sensor is part of the selector lever assembly.

All vehicles

1. Place the selector lever in the D position.





2. Gently pry up to remove the selector lever trim ring.





3. Lift the center console lid and remove the center console compartment tray.





4. Remove the top finish panel from the center console.





5. Disconnect the power outlet electrical connector.





6. Remove the selector lever cable from the selector lever assembly.

1. Disconnect the selector lever cable end from the selector lever.

2. Remove the selector lever cable from the selector lever bracket.





7. Disconnect the TR sensor electrical connector and disconnect the wiring harness fastener from the selector lever.





8. Disconnect the wiring harness retainers from the selector lever.





9. Disconnect the electrical connectors from the selector lever.

1. Disconnect the selector lever electrical connector.

2. Remove the vehicle harness connector from the selector lever.





All-Wheel Drive (AWD) vehicles

10. Pull the All-Wheel Drive (AWD) module straight back and remove it from the back of the selector lever.





All vehicles

11. Remove the 2 screws from the center console.





12. Remove the 4 bolts and remove the selector lever assembly.
- To install, tighten to 25 Nm (18 lb-ft).





13. To install, reverse the removal procedure. Adjust the selector lever cable. For additional information, refer to Selector Lever Cable Adjustment External Controls.