Audio Control Module (ACM)

Audio Control Module (ACM)

Base AM/FM









Single CD, CD6









Navigation









Removal and Installation

NOTE: It is not necessary to remove the Audio Control Module (ACM) to retrieve the part number. For additional information, refer to Audio Control Module (ACM) Self-Diagnostic Mode Audio Control Module (ACM) Self-Diagnostic Mode.

All except base AM/FM

1. NOTE: Module configuration is required when a new ACM is being installed.

Upload the ACM configuration information to the scan tool . For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programming and Relearning

Base AM/FM

2. Remove the center instrument panel finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.

Single CD, CD6

3. Remove the Front Controls Interface Module (FCIM). For additional information, refer to Front Controls Interface Module (FCIM) Front Controls Interface Module (FCIM).

Navigation

4. Remove the Front Display Interface Module (FDIM). For additional information, refer to Front Display Interface Module (FDIM) Front Display Interface Module (FDIM).

All Audio Control Modules (ACMs)

5. Remove the 4 screws and the ACM.
- Disconnect the electrical connectors.

6. To install, reverse the removal procedure.
- For all ACMs except base AM/FM, download the configuration information to the ACM. For additional information, refer to PMI in Information Bus. Programming and Relearning