Electronic Brake Control Module: Service and Repair

Anti-Lock Brake System (ABS) Module













Removal and Installation

NOTICE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.

1. NOTE: This step is necessary only if a new ABS module is being installed.

Connect the scan tool and upload the module configuration information from the ABS module.

2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.

3. Disconnect the ABS module electrical connector.

4. Remove the 4 screws and the ABS module.
- To install, tighten to 3 Nm (27 lb-in).

5. To install, reverse the removal procedure.
- When installing a new ABS module, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in this procedure). For additional information on configuration, refer to Programmable Module Installation (PMI) in Information Bus. Programming and Relearning