Generator - Single Generator

Generator - 6.4L Diesel, Single Generator









Removal and Installation

1. Disconnect the batteries. For additional information, refer to Battery.

2. Remove the Air Cleaner (ACL) assembly. For additional information, refer to Fuel Delivery and Air Induction.

3. Remove the fender splash shield.

4. Rotate the accessory drive belt tensioner clockwise and remove the drive belt from the generator pulley.

5. Remove the nut and position the generator B+ terminal aside.
- To install, tighten to 17 Nm (150 lb-in).

6. Disconnect the generator electrical connector.

7. Remove the 2 lower bolts to the generator.
- To install, tighten to 47 Nm (35 lb-ft).

8. Remove the upper bolt and the generator.
- To install, tighten to 47 Nm (35 lb-ft).

9. To install, reverse the removal procedure.